http://www.openzwave.com/device-database/0086:0059:0102 images/aeotec/zw089.png https://products.z-wavealliance.org/products/1179/ Recessed Door Sensor Gen5 Press and hold the Z-Wave button for 5 seconds will trigger sending the Wake up notification command and then keep waking up for 10 seconds after release the Z-Wave button. https://Products.Z-WaveAlliance.org/ProductManual/File?folder=&filename=Manuals/1184/Recessed Door Sensor Gen5 - Manual MCert.pdf Turn the primary controller of Z-Wave network into inclusion mode, short press the product’s Z-Wave button that you can find in the back of the product. U.S. / Canada / Mexico ZW089-A Press and hold the Z-Wave button that you can find in back of the product for 20 seconds and then release. This procedure should only be used when the primary controller is inoperable. Turn the primary controller of Z-Wave network into exclusion mode, short press the product’s Z-Wave button that you can find in back of the product. The Aeotec by Aeon Labs Recessed Door Sensor Gen5 is a door sensor that can detect the state of the door's open/close. It will report the door state to your controller/ gateway/associated nodes in real time when the state of your door has a change. It’s a security Z-Wave device that supports security encryption. Also it supports the “Over the Air Firmware Updating” that allows you wirelessly update its firmware if needs. It can be included and operated in any Z-Wave network with other Z-Wave certified devices from manufacturers and/or other applications. Initial Metadata Import from Z-Wave Alliance Database - https://products.z-wavealliance.org/products/1179/xml Updated Metadata Import from Z-Wave Alliance Database - https://products.z-wavealliance.org/products/1183/xml Updated Metadata Import from Z-Wave Alliance Database - https://products.z-wavealliance.org/products/1184/xml https://products.z-wavealliance.org/products/1183/ Australia / New Zealand ZW089-B https://products.z-wavealliance.org/products/1184/ CEPT (Europe) ZW089-C Which value of the Sensor Binary Report will be sent when the magnet switch to open/close. Which value of the Basic Set will be sent when the magnet switch to open/close. Enable/disable the function of low battery checking, when the current voltage is less than the warning voltage, it will send the Battery Low Warning Report. This parameter is available when the low battery checking function is activated or the device was waked up by other actions (i.e. the z-wave button trigger, magnet switch trigger and the Wake Up Interval Set timeout trigger). The Recessed Door Sensor will check the battery power when it was wake up as other ways. For example: the z-wave button trigger, magnet switch trigger and the Wake Up Interval Set timeout trigger. Default setting: 86640 Configure which sensor report will be sent when the sensor is Opened/Closed Lock/ unlock all configuration parameters Device Tag Reset to factory defaults. true